{Chrysler 300} Re: 57 300C / Wire Terminals Needed

["'Warren Anderson' via Chrysler 300 Club International" <chrysler-300-club-international@xxxxxxxxxxxxxxxx>]

Hello Group,

I want to thank everyone who tried helping me find these special terminals.  I worn-out the internet without any luck.

I will think of something.............

Regards,

Warren Anderson

---

From: Warren Anderson <warren.anderson1960@xxxxxxxxx>
Sent: Thursday, December 5, 2024 6:43 AM
To: chrysler-300-club-international@xxxxxxxxxxxxxxxx <chrysler-300-club-international@xxxxxxxxxxxxxxxx>
Subject: 57 300C / Wire Terminals Needed

 

Hello Group,

      I need a little help.  I'm building a new wire harness for my 300C.  I'm working on the wiring harness from the blower switch over to the blower motor.  The motor connection is made up of 1 x 4-pin plug housing which fits into the motor connection.

      I have 100s of electrical parts, but I do not have the terminals needed to retain the 4-pin plug housing.  I have attached a few photos of the terminals I need.  Notice the signal slot, once the terminal is inserted into the housing the very end of the terminal gets bent slightly to keep the terminal in the housing.  

If anybody has such terminals or knows where to source them, please let me know.  I'm looking for a hand full.

length = 120 mm

width = 7 mm

thickness = 1 mm

Best Regards,

Warren Anderson

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/CH2PR10MB3927D5A6237DA7A390690FEBF0312%40CH2PR10MB3927.namprd10.prod.outlook.com.