George,
I havent made it out to the garage yet, but an idea just occured to me.
Perhaps the door latch is "locked", by key. Have you tried the key?
If you determine the door is not "locked", then you should be able to hook
the rod that connects to the outside handle and pull up.
If the door is locked by key and you don't have a key, you either have to
take out the seats and go thru the doorpanel, and remove the keylock from
the door (it is held there by a slide clip).
This last tip is a bit violent, but If you plan to replace all the
locks, ( they are available NOS), you might try running a screw into the
keyhole, and then pull the cyinder out of the lock, so you can then operate
the lock with a screwdriver.
----- Original Message -----
From: "George Sazdoff" <[email protected]>
To: <[email protected]>
Sent: Sunday, August 19, 2001 5:32 AM
Subject: [FWDLK] Door Mechanism 57 Plymouth Belvedere Conv.
> Hi Everyone. You may have remembered my previous posts concerning the
jammed
> door mechanism on the drivers side of my newly acquired 57 Conv. I just
got
> the car home, and cannot get the drivers side door to open, I can't get
the
> door panel off due to lack of clearance (front seat). I can see the
> mechanism through the top,since I removed the window garnish moulding.
The
> window is down (PW) which helps to see it. My question is: What do I
> pull, push, wiggle, (curse at), to get the door to open; and I think the
> manual will help me from there. Any help would really be appreciated!
> Thanks George.
>
|
|
Back to the Home of the Forward Look Network