1960 Imp problems - any help?

["jsadowski" <jsadowski@xxxxxxx>]

These are the same up through 63 Imperial. If you can't get the regular bushing, get the ball bearing conversion kit. These seem to be readily available & don't seem to wear out. I put one in my 60 14 years ago & it is still fine.

John

----- Original Message -----

From: DIETMAR FRENSEMEYER

To: mailing-list@xxxxxxxxxxxxxxxx

Sent: Thursday, August 26, 2004 11:51 PM

Subject: IML: 1960 Imp problems - any help?

Hi � Yesterday I inspected my 1960 Dream Car and found the diff  leaking. Not that easy to open the plug  - 400 nm torque needed �

Found a stock oil sealing ring and wished John Rosen to hell � again � he sold me the rear axle �completely redone� � with lots of pictures  - but this sealing was stock 44 Years old. So far to John Rosen � again.

When under the car I checked the front suspension and found the idler arm bushing damaged .

Bought it three years ago from Bernbaum .. not the  dream car quality at all  - 2000 Miles  is rather bad for this part.

Here comes my question: is there any PU bushing for this car, may be it is all the same for the A, B, C, D, body?  

Perhaps any MOPAR stuff?

 

 

Dietmar

1960 fds

www.movit.de/htm/imp60hom.htm