Epoxy would be one solution. Unfortunately, I can't remember the name of the
stuff, but you can buy it at Wal-Mart. It comes in a srynge that has a part
a/b already in there, so that when you squeeze a portion, it comes out in the
proper ratio. All you have to do is just mix it up. Setting time is around 20
minutes, and full cure around 24 hours at 70-80 F. What's nice about the stuff
is that you can sand it (even use it as a filler) and prime over it or dye over
it in your case.
I use the stuff all the time when I put together my resin models.
Chris Middlebrook
62 Custom Southampton
--- On Fri 07/09, < DONALDDICKINSOND@xxxxxx > wrote:
From: [mailto: DONALDDICKINSOND@xxxxxx]
To: mailing-list@xxxxxxxxxxxxxxxx
Date: Fri, 9 Jul 2004 13:07:04 EDT
Subject: IML: Need adhesive for poly-plastics
<HTML><FONT FACE=arial,helvetica><HTML><FONT SIZE=2 PTSIZE=10
FAMILY="SANSSERIF" FACE="Arial" LANG="0">The small trash bin in my '55 has some
cracks and a loose tab that I would like to fix.� The normal plastic adhesive
does not work as, it feels like, this item is either polypropylene or
polyethylene.� Any good suggestions?</FONT></HTML>
<p>
_______________________________________________
Join Excite! - http://www.excite.com
The most personalized portal on the Web!
Back to the Home of the Forward Look Network