Electrical problems, Imperial-59

["Timothy J. LaPean" <pctocso@xxxxxxxx>]

The brake lights are controlled by a
pressure-activated switch that screws into the under
side of the master cylinder.  And they work even if
the car's ignition is turned off.

The thing on the brake is probably for the auto-pilot.
 

Sometimes people wire their own brake light switch on
the pedal because the pressure switch is a little slow
to respond and they can leak eventually.  So it could
be that too, but if it was it would probably look odd
because it would not be original.

Timothy

1960 Custom Southampton 4dr
"Virgil"


 --- Anders Nilsson
<nilsson.anders@xxxxxxxxxxxxxxxxxxxxxxxxx> a �crit�: >
Hello everybody on IML
> 
> For a couple week ago I found out that the wiring
> harness is damaged by 
> fire in my Imperial -59 and I have started to create
> a new wiring harness. 
> When I started this job  I found out that a small
> pedal is connected to the 
> electric system.This pedal is mounted behind the
> brake pedal and it is 
> black with a small grey rubber.
> 
> I wonder what is the function for this pedal ?
> 
> I also need help to find wirinig diagram for the
> auto pilot, this wiring 
> harness is disconnected from the car and I don.t
> know where I will connect 
> this wiring harness into the electric system.
> 
> On the main cylinder for the brakes there is a
> switch mounted,  is this for 
> the stop lights, if it is for the stop lights what
> is the function for the 
> switch mounted on the brake pedal, is this  for the
> auto pilot ?
> 
> 
> Regards
> Anders
> Sweden
> 
> Imperial 4-door HT -59
> Studebaker Coupe -55
> Studebaker lead sled -55
> 
> 
> 
>  

___________________________________________________________
Do You Yahoo!? -- Une adresse @yahoo.fr gratuite et en fran�ais !
Yahoo! Mail : http://fr.mail.yahoo.com