|
|
| Vote for The Forward Look Network on the Mopar Top 100 Sites |
From: Kenny J.
Email: [email protected]
Remote Name: 63.191.9.236
Date: May 07, 2003
I installed my H.E.I. distributor from Langdon's Stovebolt. It wasn't very difficult and I won't have to deal with points or condensers anymore! Tom has grafted an '82-'84 Chevy/GMC S series 2.8 V-6 distributor to a Mopar flat head six distributor shaft. I ordered the optional round coil and it fit my engine's original coil bracket, though I needed a longer screw on the bracket. Tiis is because the new 12 volt coil is larger in diameter than the original. You will also need to run a ten gauge wire directly from the ignition switch to the coil. Here's a link to Tom's web site: http://www.stoveboltengineco.com/index1.htm
