|
|
| Vote for The Forward Look Network on the Mopar Top 100 Sites |
From: Mopar Randy
Email: [email protected]
Remote Name: 152.163.189.70
Date: December 17, 2002
Time: 02:12:23
The sockets just pull out of the housings. They are just held in by the little tangs on the socket. Just kind of rock them sideways and they should just pop out. Notice that there is a larger spacing at the top of the socket tangs which corresponds to a small tab in the lame assembly. Make sure to line the wide part of the socket up with the little tab in the lamp assembly when you put it all back together. Mopar Randy
