|
|
| Vote for The Forward Look Network on the Mopar Top 100 Sites |
From: lee
Email: [email protected]
Remote Name: 198.97.67.57
Date: September 19, 2002
Yes I believe that there would be plenty of stock left for a turning/sleeving operation. I looked at the pits on the drum and found the worst were about .030" deep. However, where would I find the tolerance limits for this kind of salvage operation on the drum? Would that be something a machinist could come up with, or would I have to chase down a Chrysler salvage/rework spec? what kind of damage would the pits create on the bands if the pits were left after smoothing the surface?
