|
|
| Vote for The Forward Look Network on the Mopar Top 100 Sites |
From: Brian Cooper
Email: [email protected]
Date: April 18, 2001
It can't be a 360. The casting number is G340D33770150, but I am not sure about the letters, they are hard to read. It also has the smaller balancer and flexplate. The motor is going into the project truck. I think I misread the cyl. since I didn't knock the carbon off before I read the micrometer. That, and I almost always screw up reading a micrometer. I believe the 340 in the serial number is the tell tale here. What do you know about 904's. I got one in the deal with the motor. Are they worth using since it was free, or should I look for a 727?
