|
|
| Vote for The Forward Look Network on the Mopar Top 100 Sites |
From: Justin
email: [email protected]
Date: August 13, 2000
Time: 22:05:52
I'd be very interested in pictures of the square aluminum plates you mentioned earlier. If I read you right, you remove all holes except for a single hole which you cover with an aluminum plate. You then drill holes in this plate, as necessary, to allow the various hoses to pass through. Is that close to correct? Do you seal the holes with rubber grommets? What method do you use to fill any holes you no longer need? Do you use any special heatproofing along the firewall? Is it different than the soundproofing we've already talked about?
Thanks!! Justin
