Re: Ignition switch wiring
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Ignition switch wiring



What is the  problem that persists? 

Thanks,
Gary H. 

>  -------Original Message------- 
>  
>  It appears I have a malfunction in my ignition wiring.
 
>  I replaced the ignition switch but the problem persists.
>  
  The wiring schematic shows TWO wires attached to the "Ignition" terminal of
>  the switch.
>  One wire to the oil pressure light and the other goes to the coil.
>  
>  
>  Is this because the oil pressure light should come on while starting the
>  engine?
>  
>  
>  Thanks,
>  Doug 

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.





Home Back to the Home of the Forward Look Network


Copyright Š The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.