[AD removed for archives] ------------------------------------------------------------------- Get a Free Sirius Satellite Package, don't pass on this! caadGKVbOyW3Na/ProductTestPanel ------------------------------------------------------------------- On 27 06/30/05, Nick Tiberio wrote: > I wanted to swap out my 1963 741 2:76 open rear for a mid-3 sure grip > unit. I called Randy's Ring & Pinion and they set me up with a 742 3:55 > SG unit with new yoke/u-joint/axle bearings/seals, nice. I asked if this > was a direct swap they said yes. I further questioned them and faxed > them an article about axle lenght problems. They said there was no > problems they new of, and never saw the information that I had sent > them. They will set me up with everything and I'll have no problems. > Now that the car is on the lift and all apart, here's how my day went. > The inner and outer axle seals would not fit, way to big. I called > Randy's and they're not sure what will work and gave me some new part > numbers and said for me to try NAPA. The axle bearings would not fit, > way to big, they can't understand why, but call them tomorrow and let > them know how I made out. > I will call as I must let them know that my axles from my 741 case will > not fit the 742 case as they are about 1/8" to long. > > Just remember this: > Axle 2070573 - 741 case w/o SG axle length 30 1/2" > Azle 2404050 - 742 case w/SG axle length 30 7/16" It is maddening. These guys not only claim to be experts, all the Mopar print media outlets routinely make similar claims in various tech articles on their behalf (perhaps in exchange for free or discounted parts that the journalist were bolting on to their project Roadrunner or Coronet R/T.... MGC is possibly excluded, because they don't do tech articles, ....) I called Randy's about 5 or 6 years ago when I discovered this very same axle length problem myself on my 63 Dodge... the tech guy I spoke with continually pimped the green bearings saying it'd solve all the end-play adjustment problems,,, to which I made several attempts to describe the problem in different terms, hoping he'd get it. Even when I stated that the thrust block on the two different diff's measured out to different widths, and even pointed out the different PNs on the axles... he *still* insisted that green bearings would fix it. I finally gave up and told him "thanks, but no thanks", to which I think he ended with another pimpin' of those F@#$!*ing green bearings!!! Certainly you and I aren't the only ones to ever call them about this issue, yet despite making 8-3/4"s their business and claiming to have knowledgable tech guys on staff, they *still* won't address this. I'm sorry to hear that you are in this situation. I ended up using a 66-67 b-body housing & rear. For me, that was a means to an end. Doug Ahern Athens, GA [AD removed for archives] ------------------------------------------------------------------- Get a Free T-Mobile Sidekick II plus $500 towards service! Click here. caadGKUbOyW3Nf/ProductTestPanel ------------------------------------------------------------------- ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html. bOyW3N.
Copyright © The Forward Look Network. All rights reserved.
Opinions expressed in posts reflect the views of
their respective authors.
This site contains affiliate links for which we may be
compensated.